|
Post by oklab on Nov 22, 2005 23:04:07 GMT 8
346 fps? Not bad...not bad at all for something with a plastic gearbox. Ang talagang bitin lang ang mag…only around 26 bbs’ per load. Btw, are there already hi-caps available, aside from the tm and ca brands?
|
|
|
Post by SANDMAN on Nov 23, 2005 4:03:29 GMT 8
Try kmi gawa next week sir... pareho kami may mga sugat sa kamay ng kasamahan kong si abu-OMENG eh. Pinapagaling lang namin para hataw ulit.. hehehe...
|
|
|
Post by oklab on Nov 25, 2005 20:10:32 GMT 8
Hi Stan. I was hoping that you could tell me more regarding the XM8 and the procedure you did to solve its inaccuracy. You mentioned that with a sandpaper and a needle file that you were able to correct it in no time at all. I already got an XM8 and I noticed that it is terrible when it comes to its accuracy. The BBs’ seem to shoot higher than it’s supposed to. I do not suspect that it’s a matter of hop-up adjustment because the BBs don’r really curve on an upward direction, but rather shoots straight-up.
Could this be because of the flash hider? If so, how much should I sand-off and how would a needle file be of any help? I hope you can explain to me the procedure because it’s such a waste that a powerful gun like the XM8 would lose in a battle because of this. Thank you very much for all the things you’ve been sharing with us!
|
|
|
Post by SANDMAN on Nov 28, 2005 0:16:40 GMT 8
Correct sir, it's the clearance with the flash hider. Just sand-away or file-away the inner parts until no contact is made with the passing bb. Trial and error lang sir... good luck
|
|
|
Post by snyper on Dec 16, 2005 6:14:04 GMT 8
|
|
gh0st R@ven
Tenyente
...I am the one called "DOC"
Posts: 1
|
Post by gh0st R@ven on Dec 28, 2005 10:14:51 GMT 8
what other internal upgrades can the ver3 gearbox take? ie what parts from which manufacturer.
|
|