|
|
Post by xyphoid on Feb 6, 2007 13:52:43 GMT 8
Mga sir ask lang ako which piston head would apply sa cone shaped head ng cylinder head na ito? and if its ok to use ordinary aluminum piston head with bearing??
i also observed that the stock m4 marui airseal nozzle feels tight in this cylinder , may nakaobserved din ba nito mga sirs??
thanks !!
|
|
|
|
Post by miklo on Feb 6, 2007 17:16:00 GMT 8
im sure meron din src phead na compatible dyan....
yan talaga ang trademark ng src....meron silang sariling measurement na microns lang ang diff w/ other aftermarket prods but makes a lot of difference....
|
|
|
|
Post by Han_Solo on Feb 6, 2007 19:06:49 GMT 8
Sir observation ko lang po regarding the matching of cone shaped cylinder(brass CA) with aluminum piston head(SYSTEMA): trial & error po with the proper meshing of the sector gear teeth & the piston body teeth. I added a 1/16inch washer/spacer (between the piston head & the piston body)for proper meshing of the teeths. I found this out by destroying in 2 weeks time, a brand new deepfire polycarb piston. Nag o-overlap yung sector gear teeth with the piston body teeth, hindi sakto yung kagat. My replacement piston body's teeth still looks fresh in a months usage so far... Just sharing.  |
|
|
|
Post by ZeeZeeTop on Feb 7, 2007 2:13:37 GMT 8
match mo yan sa silent pistonhead... just make sure na non boreup yung bibilhin mo at wag yung boreup, same kasi ang itsura nung silent pistonhead at boreup pistonhead... ok man lang rin na gumamit ng aluminum pistonhead as ito ang ginagamit sa stock CA CQB, but its better for your gearbox to use a silent pistonhead or kung wala kang makita na ganun, a polycarbonate or duracon pistonhead would suffice...
hope this helps you out...
|
|
