|
|
Post by mykol73 on Aug 8, 2008 16:32:14 GMT 8
kakabuy ko po ng techpro flash motor..
napapaputok ko ng 1 mag after that ayaw na po pumutok..
got it out of the handgrip and tested it outside ayaw po umikot..pero when i turned my pinion..umandar ulit..what po problem with the motor?
|
|
|
|
Post by miklo on Aug 8, 2008 22:39:54 GMT 8
meron siguro lumuwag na wire...sa coil/armature.
|
|
|
|
Post by SANDMAN on Aug 9, 2008 0:49:15 GMT 8
Also check for proper contact with your carbon brushes. If they weren't properly broken in. That would be one possibility. You can also try cleaning the contacts.
Pero parang 80% sold ako dun sa duda ni sir Miklo. May ganun din nangyari sa akin bago lang(last sunday).
Pinilit ko pa patakbuhin after a comprehensive cleanup of the motor. Bumigay din eventualy, naputol na talaga ang wires sa loob.
|
|
|
|
Post by mykol73 on Aug 9, 2008 17:42:29 GMT 8
pinapalitan ko po sir..gonna observe it po talaga for now..
sana wala na problems..pinalitan ko lang po ung pinion..
lumuluwang talaga pinion niya.
|
|
|
|
Post by Lowlight on Aug 13, 2008 22:26:35 GMT 8
my comment is non technical but more of ecomonics mga sirs, classic situation of cost vs. quality. lower the cost lower the quality and/or chamba chamba quality. higher the cost higher quality and higher probability of uninterrupted enjoyment hehehe... my two cents
|
|
